What is the heat dissipation of the system?
The whole system should run on average at 1000 BTU/hr and a maximum at 1500 BTU/hr.
It is in the end a very small system and it does not run with a lot of Watts.
Related Articles
Connect To Microscope
The microscope can be connected via the ONI software called NimOS : Click on Acquire, and then click on Connect To Microscope: In the pop-up window, click on Confirm And Connect to proceed with the connection: Wait for the initialization to finish. ...
What slides/samples are compatible with the system?
The Nanoimager works optimally with #1.5H coverslips, which have 170µm thickness. The most popular chambers are: ibidi (µ-Slide 8 Well Glass Bottom, No. 1.5) ] Lab-Tek (Nunc™ Lab-Tek™ II Chambered cover-glass, No. 1.5) 35 mm petri dishes with #1.5 ...
FAQ
What slides/samples are compatible with the system? The Nanoimager works optimally with #1.5H coverslips, which have 170µm thickness. The most popular chambers are: ibidi (µ-Slide 8 Well Glass Bottom, No. 1.5) ] Lab-Tek (Nunc™ Lab-Tek™ II Chambered ...
Temperature Control
Temperature Control: Target: set the target temperature. All the thermistor readings can be monitored in the Microscope Box Temperature tab: Current: show the temperature feedback in real-time, averaged from all thermistors. Hover around the current ...
Camera calibration with NimOS 19.7 (and above)
The procedure takes around 10 min INSTRUCTIONS: 1- Log in the Nanoimager laptop with an administrator account 2- If not already done, Download CODI Acquisition from the following link (1gb) here 3- Install CODI Acquisition and accept every prompt ...